Fixed fire retardant aging resistant one component silicone for electronic and electrical power supply

Lb-9002: This product is a neutral curing organic silicone adhesive with excellent insulation, good adhesion, moisture resistance, earthquake resistance, corona resistance and leakage resistance. The adhesive has good adhesion to metal and most plastics,

After curing, it has excellent cold and hot alternating resistance (- 60 ~ 200 ℃).

Application:

1. It is used for bonding, positioning, reinforcing and moisture-proof sealing of electronic components on electronic circuit board.

2. Engineering plastics, metals, glass and ceramics are bonded and sealed.

3. Used for bonding and waterproof sealing of guardrail tube in photoelectric industry

Technical performance:

Black / White / gray viscous paste

Density (g / cm3) 1.5-1.6

GB/T13354-92

Surface drying time (25 ℃, min) ≤ 6

Curing time (25 ℃, H) ≤ 24

Tensile strength (MPA) 0.8

GB/T528-2009

Elongation at break (%) 50

GB/T528-2009

Shear strength (MPA) ≥ 0.8

GB/T7124-2008

Hardness (Shore A) 50 ～ 60

GB/T531.1-2008

Use temperature range (℃) - 60 ~ 200

Dielectric constant (100kHz) ≤ 3.0

GB/T1693-2007

Dielectric strength (kV / mm) ≥ 18

GB1695-2005

Volume resistivity (Ω. Cm) ≥ 1.0 × 10 14 GB / t1692-2008

usage method:

1. Clean the surface of glued or coated materials to remove rust, dust and oil.

2. First put on the rubber nozzle, then cut the rubber nozzle into the required size, and then squeeze the glue liquid onto the cleaned surface to make it evenly distributed, and then close and fix the glued surface.

3. The coated parts can be put into use after 24 hours curing at room temperature in air.

matters needing attention:

1. Curing needs moist air and may take a long time in the case of large bonding area.

2. After the operation, the unused glue should be immediately tightened and sealed. If there is a little crust on the seal, remove it,

It does not affect the normal use.

3. Avoid contact with eyes, skin and clothing. Wash with soapy water immediately after skin contact. If it splashes into your eyes, please flush immediately with plenty of water

If you still feel unwell, go to the hospital for examination.

4. If the dispensing machine is used for sizing, it is recommended to soak the dispensing needle in a container containing silicone oil at the end or interruption of the operation, so as to prevent the needle from being blocked by solidification. When the operation is repeated, remove a small amount of glue from the needle.

Storage: store in a cool and dry place below 30 ℃, 2.6l/tube for 6 months, 300ml / tube for 9 months, 45g / tube for 12 months.

Package specification: 45g / piece, 300ml / piece, 2600ml / piece or as required by customers.

Explanation: the above data are based on our extensive experiments and the results are reliable. However, due to the diversity of practical applications, the application conditions are beyond our control, so users need to test before use to confirm whether the product is applicable. Our company does not guarantee the use of our products under specific conditions of the problem, do not bear any direct, indirect or accidental loss liability. Users in the process of using any problems, you can contact our technical service department, we will try our best to provide you with as much help as possible